Rear king air bump stop with evo double throwdown lever track bar bracket>

jeeper52

LOSER

• May 24, 2015

• #1

Hi guys i was wanting to see if someone can post a pic of how you attach the air bump to the new evo track bar bracket? It appears to be setup for a stock bump stop. How does the king air bump attach??

 

ridg3runner

-

• May 24, 2015

• #2

jeeper52 said:

Hi guys i was wanting to see if someone can post a pic of how you attach the air bump to the new evo track bar bracket? It appears to be setup for a stock bump stop. How does the king air bump attach??

Click to expand...

The air bump bracket has to be welded into (frenched) into the frame where the OEM bump stop is located.

 

jeeper52

LOSER

• May 24, 2015

• #3

ridg3runner said:

The air bump bracket has to be welded into (frenched) into the frame where the OEM bump stop is located.

Click to expand...

Ok thanks. So you dont use the track bar relocation bracket on the frame side then?

 

jeeper52

LOSER

• May 24, 2015

• #4

This is the bracket im talking about.

 

Attachments

• 
  20150524_153425.jpg

  55.6 KB · Views: 149

Yeti-09

New member

• May 25, 2015

• #5

Set up the new frame side track bar bracket per the instructions, only tack weld at this time . Cut it off where it bends to the rear. Remove factory track bar bracket. Place the new EVO King bump stop bracket into place, trim to fit around new track bar bracket. Cycle the suspension to check clearance- fully weld once everything is set correctly. Then go fast...

 

jeeper52

LOSER

• May 25, 2015

• #6

Thanks Yeti. So i will end up cutting off the section of the new trackbar that holds the factory bump stop?