Rebuild Ball Joint?

Mtb275

Member
Recently I purchased a PR44 front. During inspection, I found the rubber on the lower driver side Ball Joint pushed out.

What is the solution for this? A rebuild kit? New Ball joint? Not worry about it?

Overall photo
IMG_1883.JPG
Front side of rubber on Ball joint looks good.
IMG_1881.JPG

Back side of rubber pushed out.
IMG_1880.JPG
IMG_1882.JPG


Sent from my iPhone using WAYALIFE mobile app
 
Recently I purchased a PR44 front. During inspection, I found the rubber on the lower driver side Ball Joint pushed out.

What is the solution for this? A rebuild kit? New Ball joint? Not worry about it?

Overall photo
View attachment 234777
Front side of rubber on Ball joint looks good.
View attachment 234778

Back side of rubber pushed out.
View attachment 234779
View attachment 234780


Sent from my iPhone using WAYALIFE mobile app

As long as there is no grease weeping out of the boot, they are ok, otherwise you will need to contact us at 714-421-4314 and get replacement seals. Also, on the bottom ball joint the rubber seal protrudes from the housing, whereas the top one does not.
 

Mtb275

Member
As long as there is no grease weeping out of the boot, they are ok, otherwise you will need to contact us at 714-421-4314 and get replacement seals. Also, on the bottom ball joint the rubber seal protrudes from the housing, whereas the top one does not.

Thanks for the reply.

Grease comes out like crazy. I'll be calling tomorrow.



Sent from my iPhone using WAYALIFE mobile app
 
Top Bottom