bruggymonster
Member
To start off I have a 2013 JKUR with 37s. So about a week ago I decided switch the gear ratio to 4:10 on the programmer so it would be correct for the rubicon axle ratio and it felt like it was not shifting at the right points. After I did this, I felt a loss of power and/ or a loss of maybe 1st, 2nd, or 3rd gear. After driving about 5 miles I got a check engine light so I flashed the code and got P0733 and know that it is an error in the 3rd gear. I quickly pulled over and changed the gear ratio back to 3:73 and cleared the DTCs and it ran fine. After a week of spring break and no driving, I came home and drove about 1 mile and the check engine light came in with the same code and is now doing the same thing. What do I diagnose this as/ has anyone else had this problem before? Also am I good to drive it for now or should I park it until it's fixed?
Any and all comments are welcomed, I'm freaking out because the engine and tranny only have 54,000 miles on them.
Any and all comments are welcomed, I'm freaking out because the engine and tranny only have 54,000 miles on them.