novyt
New member
Hello,
I would like to ask for advice on whether someone has encountered a similar problem like me. When braking, the ABS system lightly jumps into the brake pedal. The problem occurs irregularly. He can ride it, but it's unpleasant. The Jeep does not show any error messages and no problem is seen on diagnostics. All bearings and ABS sensors were replaced on the vehicle, all ABS wiring and control unit were already tested, the ABS / ESP / TCS firmware updated. My service technician, a Jeep electronics specialist, is unfortunately not aware of this and suggests replacing almost the entire system including complete cabling.
Thanks for any advise,
Tomas
Jeep Wrangler Rubicon 2010 EU version 2.8CRD, tire 33 ", RCV axlesshafts
I would like to ask for advice on whether someone has encountered a similar problem like me. When braking, the ABS system lightly jumps into the brake pedal. The problem occurs irregularly. He can ride it, but it's unpleasant. The Jeep does not show any error messages and no problem is seen on diagnostics. All bearings and ABS sensors were replaced on the vehicle, all ABS wiring and control unit were already tested, the ABS / ESP / TCS firmware updated. My service technician, a Jeep electronics specialist, is unfortunately not aware of this and suggests replacing almost the entire system including complete cabling.
Thanks for any advise,
Tomas
Jeep Wrangler Rubicon 2010 EU version 2.8CRD, tire 33 ", RCV axlesshafts