Left blinker wiring problem

Arkk1229

New member

• Aug 19, 2017

• #1

When i turn my headlights on the left blinker on the dash stays on constant but the blinker wont turn on all the way its barely on. Is it just a bad bulb or wiring?

 

PT1400

New member

• Aug 19, 2017

• #2

Shouldn't be a bulb. The only bulb that could would be the rear left tail light, if you haven't changed over to LEDs. Four screws and you can check that out. After that, start looking into the wiring. If you don't have a service manual, get one. They come with wiring diagrams.

 

Benito

Caught the Bug

• Aug 19, 2017

• #3

You are low on blinker fluid. Add blinker fluid to the front and rear blinker housings


Sent from my iPhone using WAYALIFE mobile app

 

O

oldroadie

New member

• Aug 19, 2017

• #4

Swap out the relay, they get dirty like everything else.


Sent from my iPad using WAYALIFE mobile app

 

Arkk1229

New member

• Aug 21, 2017

• #5

A wire was pinched i stripped it and soldered it back together.

jeep life

 

O

oldroadie

New member

• Aug 22, 2017

• #6

Yes! Free repairs are the best!


Sent from my iPhone using WAYALIFE mobile app

 

FallonJeeper

New member

• Aug 22, 2017

• #7

I had a similar issue. Wire to the left side marker light was worn through the insulation and rubbing the hole in the fender where the wire feeds to the lense. Kept blowing the fuse.
I changed the turn signal unit on the steering column and traced the wires through the firewall before I went to the obvious problem.

From now on, I work from the light back to the switch.

Sent from my SM-G930V using WAYALIFE mobile app