MANTIS Jk build
- Thread starter Mantisjk1
- Start date
Mantisjk1
New member
Right now the jeep has a 2.5 bb from Rough Country, 35in Firestone Destination Mud Terrain, chopped front and rear bumper with Olympic 4x4 winch mount plate holding a smittybilt x20 10k waterproof winch. Also I have a hi lift jack mount from Amazon. Cut rubi rock rails.
Sent from my SM-S727VL using WAYALIFE mobile app
Sent from my SM-S727VL using WAYALIFE mobile app
2007 JKU CANADA
Hooked
Nice start to your build. I like how you have the winch mounted into the stock bumper
Mantisjk1
New member
Thanks that is the Olympic 4x4 winch mount plate and I had to do alot of cutting from the original bumper to make it fit
Sent from my SM-S727VL using WAYALIFE mobile app
Sent from my SM-S727VL using WAYALIFE mobile app
Mantisjk1
New member
2007 JKU CANADA
Hooked
Nice. I just may do the same with mine until I get my new bumper
Mantisjk1
New member
The mount was 100 bucks. But if you can spend 200 bucks I would just get the rough country stubby bumper
Sent from my SM-S727VL using WAYALIFE mobile app
AZ Explorer
Caught the Bug
I'd probably get the end caps for a more finished look, but it is a really cool set up. I like it.
Mantisjk1
New member
I would get the end caps but I going to save for a new bumper this is just to hold me over til then lol
Sent from my SM-S727VL using WAYALIFE mobile app
2007 JKU CANADA
Hooked
I just made a piece to fill in the end
you can see in the pic. 10$ but finished off the end
you can see in the pic. 10$ but finished off the end
Mantisjk1
New member
AZ Explorer
Caught the Bug
Makes sense. Darn good hold over, you did a nice job on it.
sipafz
Caught the Bug
Cool to see that you took the time to modify your stock bumper! There’s not many of us out there!
Stop by and give a wave:
https://wayalife.com/forumdisplay.php/11-Give-us-a-Wave
And if you’re interested, you can check out my DIY Hidden Winch Install here:
https://wayalife.com/showpost.php?p=836148
Mantisjk1
New member
sipafz
Caught the Bug
Thanks! I’m not planning on any further upgrade so I wanted to protect the winch from Wisconsin road salt as much as possible. The only down side is that I have to reach under the bumper to reach the clutch lever. The winch is mounted upside down so it’s not bad.
Saharaunlmtd
Caught the Bug
Mantisjk1
New member
The only part that sucks is I lost my fog lights they are to wide to fit in their with the winch. And it look weird with the holes if you could see through them so I cut the fog lights and used the lens and painted them black on the inside and silicone them in
Sent from my SM-S727VL using WAYALIFE mobile app
Sent from my SM-S727VL using WAYALIFE mobile app
Mantisjk1
New member
Debating on if I should do the whole fender delete thing lol
Sent from my SM-S727VL using WAYALIFE mobile app
Sent from my SM-S727VL using WAYALIFE mobile app
