Is this normal after driveshaft install????

N

Ny in az

Member

• Jul 7, 2018

• #1

Just did an adams 1310 extreme front install and after pulling jack out n using it as an extra pair of hands to hold up the shaft while I bolted it in I saw this. Normal?? Kinda freaking a little


Sent from my iPhone using WAYALIFE mobile app

 

VeruGE*144

Caught the Bug

• Jul 7, 2018

• #2

If there was too much grease pumped into the shaft it’ll spooge out when collapsed. It happened to me once. Do you know where it came out of? If you pushed the shaft all the way in, I would add some grease in there when you put it back to ride height.

 

N

Ny in az

Member

• Jul 7, 2018

• #3

Not sure had grease around one end of joint leading back to zerk fitting I think


Sent from my iPhone using WAYALIFE mobile app

 

black pearl

Hooked

• Jul 7, 2018

• #4

Ny in az said:

Not sure had grease around one end of joint leading back to zerk fitting I think


Sent from my iPhone using WAYALIFE mobile app

Click to expand...

In some driveshaft there is a hole by the u-joint and excess will come out of there.


Sent from my iPhone using WAYALIFE mobile app

 

N

Ny in az

Member

• Jul 7, 2018

• #5

Thx guys feeling better!!


Sent from my iPhone using WAYALIFE mobile app

 

JKbrick

Active Member

• Jul 7, 2018

• #6

VeruGE*144 said:

If there was too much grease pumped into the shaft it’ll spooge out when collapsed. It happened to me once. Do you know where it came out of? If you pushed the shaft all the way in, I would add some grease in there when you put it back to ride height.

Click to expand...

That sounds like you’ve been watching too much Jeep porn


Sent from my iPhone using WAYALIFE mobile app