Switch-Pro Help

thebandit007

New member
Hello. I have a 2018 TH and just received a Switch-Pro SP9100 switch panel. It is similar to a SPOD. I need to locate a light input (parking light or side marker wire), an ignition or ignition accessory input/wire , and a high beam, reverse light, or dome light signal/wire. Can anyone assist me with locating the ignition or ignition accessory wire and where to locate the high beam or reverse light wires? I have a led light bar on the roof, 2 light pods at the rear license plate bracket, and rock lights to install and connect to the Switch-Pro panel. I am OK when it comes to some installing add ons.
I was quoted 1100.00 to have everything installed and really dont want to spend that much. Thank you for your time.
 

Attachments

  • 15340949510206457330439826130655.jpg
    15340949510206457330439826130655.jpg
    108.5 KB · Views: 110
  • 1534094989528196680895586599650.jpg
    1534094989528196680895586599650.jpg
    118.8 KB · Views: 104

JAGS

Hooked
Give switch pros a call. They are very helpful. Might be able to give you some pointers. $1100 is nuts!!
 

Good2Go

Member
There’s a lot of info out there on installing these in JK’s, but maybe not so much in a Renegade so giving them a call is a good idea.

If you haven’t done a lot of wiring before, a Switch-Pro is a do-able task and a good learning experience.
I highly recommend doing this yourself.

Then go out and reward yourself by spending the $500 you saved on something else you really want!
 
Top Bottom