New Axles for the Jeep

monstrousmac

Caught the Bug
Well, I got my new axles for my Jeep. A Dynatrac Prorock 44 front axle with 4.88 gears, ARB Air Lockers, Reid Knuckles with Dynatrac prosteer ball joints and RCV axle shafts. The Rear Axle is a Prorock 60, Arb Air Locker, 4.88 gears and Dynatrac Axle shafts. Thanks to Mr.Elms.
 

Attachments

  • FA16D5D8-1545-4CE6-80D9-A59271458D48.jpg
    FA16D5D8-1545-4CE6-80D9-A59271458D48.jpg
    124.4 KB · Views: 224
  • B646A9D2-AECF-40C8-9EE3-8D620FFA9873.jpg
    B646A9D2-AECF-40C8-9EE3-8D620FFA9873.jpg
    98.1 KB · Views: 212
  • 08F0F4CB-1FEC-4750-B82C-665F281D5B6D.jpg
    08F0F4CB-1FEC-4750-B82C-665F281D5B6D.jpg
    96.3 KB · Views: 226
  • 4CC5DDAA-80E6-46C7-9FAD-516C89DC19BE.jpg
    4CC5DDAA-80E6-46C7-9FAD-516C89DC19BE.jpg
    89.7 KB · Views: 225
  • EF2D719F-1550-4F2B-A300-3827B49220D9.jpg
    EF2D719F-1550-4F2B-A300-3827B49220D9.jpg
    103.2 KB · Views: 237
  • 06572941-8E9A-4FC6-81C4-19BA359A7E77.jpg
    06572941-8E9A-4FC6-81C4-19BA359A7E77.jpg
    122.6 KB · Views: 247

monstrousmac

Caught the Bug
So does anyone know of a way to get a good measurement for drive shafts, without having to pull my existing axles off and bolting the new ones on and measuring? My Jeep is my daily driver.
 

13_gecko_rubi

Caught the Bug
So does anyone know of a way to get a good measurement for drive shafts, without having to pull my existing axles off and bolting the new ones on and measuring? My Jeep is my daily driver.
I tried doing this back when I swapped those same axles in. The front is pretty easy, u can just get one for a 44. The rear in mine was a total fail. You are going to either need to install and measure. Or find someone that has same setup - engine, trans, suspension, lift - and have them measure theirs. I was assured by JE Reel "they knew what I needed because they do so many" and it was inches too long when it showed up. They did make it right but valuable lesson learned.

Sent from my SM-G960U using WAYALIFE mobile app
 
Top Bottom