2014 Jeep JK 1ton build

kmac107

New member
IMG_0288.JPG IMG_0289.JPG IMG_0285.JPG IMG_0286.JPG IMG_0291.JPG IMG_0292.JPG
1 ton axle build 2008 Dana 60 from an F250 rear is a 2004 chevy2500 14 bolt

Rear
-arb
- east coast gear 5.38 shave
-Stock shafts and brakes
-stock 1410 yoke

Front
-Jessie Haines crossover weld on steering (I recommend artec for uptravel)
- arb
538 Yukon gears
Tie rod 7075 from wide open designs
Drag link 7075 from wide open designs

Stock master and stock front control arms



Sent from my iPhone using WAYALIFE mobile app
 

kmac107

New member
IMG_0290.JPG IMG_0291.JPG IMG_0292.JPG IMG_0293.JPG
Parts parts and more parts, I went with ARB lockers front and rear along with the twin compressor. Even if I did not do axles this compressor will be on every OFFROAD vehicle I own


Sent from my iPhone using WAYALIFE mobile app
 

kmac107

New member
IMG_0297.JPG IMG_0299.JPG
Shortly after the axle install I went and bought the artec trans cross member and 3 link brackets, measured and ordered wide open designs 2-1/4” 7075 aluminum links and Barnes Heims. It’s crazy how much smoother the front rides with the 3 link


Sent from my iPhone using WAYALIFE mobile app
 

kmac107

New member
IMG_0300.JPG
Next we’re wheels the steel rims on Goodyear MTRs never balanced well not blaming the tires as I know a lot of my friends run them with great success. Waited 16 weeks for trail ready beadlocks to retool the HD17s


Sent from my iPhone using WAYALIFE mobile app
 

Speedy_RCW

Hooked
Yes the axles have been under the Jeep for 1 year and I have put 15000 miles on them.

Any issue with the rear upper control arm axle mount spacing? I’m doing this right now and had to cut off the locating tabs to move the mounts in so I’d have clearance for the control arm hardware. And could you post a pic of where you drilled and tapped for the rear ARB? I have a plan for where I’ll put it but curious to see where others did as well.


Sent from my iPhone using WAYALIFE mobile app
 

kmac107

New member
IMG_0301.jpg
Trail ready beadlocks installed 8x170 bolt pattern rear uses a 2” wheel spacer / adapter to closer match the front and rear axle width
Wheels are wrapped in 37x13.5x17 cooper STT pros love this tire


Sent from my iPhone using WAYALIFE mobile app
 
Top Bottom