JK w/pr60, shock body hitting frame

Fury22

Member

• Aug 25, 2019

• #1

Hey guys

So when I flex tested on a cti trailer I found that my front shock body was contacting and bending on the frame. Have a 3.5 in coil and shock setup.
my metalcloak relocation brackets wouldn't fit on my pr60 when I did the swap...

Has anyone else run into this issue? Or know of a relocation bracket that will fix the problem? (I know coilovers would fix it but Im not ready for that yet haha). As far as I've found the only top shock mount relocation braket is made by rough country (eww), and all the lower ones don't specify compatibility with pr60s...

thanks as always:rock:

 

Clutch

Caught the Bug

• Aug 25, 2019

• #2

Evo makes shock relocation brackets. It kicks the bottom over and inch or so. Around $80 or so.


Sent from my iPhone using WAYALIFE mobile app

 

JKbrick

Active Member

• Aug 25, 2019

• #3

I like the JKS brackets but I couldn’t tell you if they fit a PR60


Sent from my iPhone using WAYALIFE mobile app

 

Fury22

Member

• Aug 25, 2019

• #4

JKbrick said:

I like the JKS brackets but I couldn’t tell you if they fit a PR60


Sent from my iPhone using WAYALIFE mobile app

Click to expand...

Yea those are what Im looking for. I want to rotate the mount 90 degrees like those do to eliminate binding. I guess ill just order some and see what happens

 

JKbrick

Active Member

• Aug 25, 2019

• #5

Fury22 said:

Yea those are what Im looking for. I want to rotate the mount 90 degrees like those do to eliminate binding. I guess ill just order some and see what happens

Click to expand...

That’s why I bought them too


Sent from my iPhone using WAYALIFE mobile app

 

TheGrendel

Active Member

• Aug 25, 2019

• #6

On a PR60. You could just cut the brackets and move them over and reweld them on.

 

Fury22

Member

• Aug 26, 2019

• #7

Found a bracket made by nemesis, they make them for pr44, pr60, and dana30/44. Should do the job hopefully:rock: