JKS adjustable front track bar

bouche03

Member
Hey guys-hoping someone out there in WOF land can help a brother out. My factory track bar bushings are shot and was looking to get JKS adjustable front TB. I picked this one specifically because I need the replacement to have a narrow neck at the axle end, ala the JKS due, to the Synergy raised mount on my PR44. I was wondering if someone with this track bar would be so kind as to measure the length on it. I need it to be able to adjust down to 32.5", which is basically factory length. I search everywhere I could on the interwebs and the JKS website, and their installation manual/spec sheet doesn't even have the length listed.

Thank you so much in advance!!

Nick
 

TrailHunter

Hooked
I bet it will be fine and adjust close to stock... I was going to buy the JKS but I went with the Synergy... I measured it before leaving the store as I was uncertain as well if it would go short enough... on the JKS website it says replaces OE so I’m sure it will work.
 
Top Bottom