Artec inner fenders and fender chop kit...very clean.

BlueRubicon

Caught the Bug
Installed these over the weekend. Artec makes nice products. And American made!!
EDIT...scroll down to reply #8, WJCO was kind enough to upright the pictures!!

62464678498__81E12C91-EF83-4188-8099-421A5B639950.jpg
IMG_3992.jpg
IMG_3996.jpg
IMG_3998.jpg
IMG_4001.jpg

Sorry about pics upside down. :shock:
 
Last edited:
Large pics get flipped sometimes.

I use a photo resizer, then post, and never have sideways pics.
 
How did you wire the lights? I have halogen lights on my JL. So I would remove the halogen pigtail and then hiw would I wire the new lights in? I am new to wiring! Thanks for your help!!!
 
Wired them into the existing marker/turn signal harness. Cut off factory plug and butt splice and shrink wrap them.
NOTE** Also...the turn signals are on the fender, and the marker light is on the Artec bracket. Problem with this is, when you are approaching an intersection, people most times cannot see the fender turn signal. I added a amber LED to the front and put on the turn signal circuit. I drilled a hole in front Artec bracket with hole saw and inserted round LED you can buy on Amazon inexpensively.
You will need the Tazer to tell the JL you are using LED turn signals.IMG_6289.jpgIMG_6288.jpg
 
Last edited:
Top Bottom