Lank's 2dr Build

Lank

Lank

Member
IMG_20170206_122645.jpg

IMG_20170206_122652.jpg

Only have to run the license plate and third brake light lines and do some joint tweaking.

Not bad for doing it alone and without a jig setup. Both of which I DO NOT recommend.. it could have been so much easier.

My tiny 35 doesn't do it justice. It does look beautiful though [emoji7]
 
Lank

Lank

Member
Also, don't space out like I did when you install your skins and leave out that one gas cap nutsert. That was a fun 20 minutes trying to drill him out :crazyeyes:
 
Lank

Lank

Member
Had an great time up on the Rausch run. Few dings and scrapes on the sliders and LCAs. I did end up sheering a zerk fitting off a control arm [emoji35]. Not looking forward to drilling that out. Lesson learned, flip the zerks upward

First of the TLC planned for Pumpkin over the next few days.

IMG_20170405_182933.jpg

Next is ball joints, unit bearings for both sides, and C gussets starting tomorrow.
 
Lank

Lank

Member
[emoji15]
IMG_20191110_102014.jpg

Courtesy of Ddays. Thanks again for making the drive out
 
Last edited:
You must log in or register to reply here.
Top Bottom