Charlie08JK
New member
I have a 2008 Jeep Wrangler X - 2 Dr
Set up:
33" Duratracs
2.5" ome heavy duty coils
Ome steering stabilizer
Rancho 9000xl adj shocks
Teraflex front and rear trackbars
Synergy drag link
AEV geometry correction brackets
Problem:
I have been trying to figure out what is causing vibration coming from my floorboard for almost four months. It mainly happens when driving uphill at 40 - 65 mph.
I've had the following checked and have proven to be in perfect condition.
Carrier bearings - rear diff
Cv joint - no u-joints in an '08 JK
Tires / wheels
Wheel bearings
Ball joints
Have installed hub centric rings and lugs
I have non-centric wheels - 7069 pro comps.
I would really appreciate if you or anyone can shed some light on this.
Thanks!
Set up:
33" Duratracs
2.5" ome heavy duty coils
Ome steering stabilizer
Rancho 9000xl adj shocks
Teraflex front and rear trackbars
Synergy drag link
AEV geometry correction brackets
Problem:
I have been trying to figure out what is causing vibration coming from my floorboard for almost four months. It mainly happens when driving uphill at 40 - 65 mph.
I've had the following checked and have proven to be in perfect condition.
Carrier bearings - rear diff
Cv joint - no u-joints in an '08 JK
Tires / wheels
Wheel bearings
Ball joints
Have installed hub centric rings and lugs
I have non-centric wheels - 7069 pro comps.
I would really appreciate if you or anyone can shed some light on this.
Thanks!