Trailoring a jk???
- Thread starter Jerms
- Start date
OverlanderJK
Resident Smartass
If its on a trailer it should be in park. If its flat towed it should be neutral.
To be clear, the transfer case needs to be in neutral when being flat towed :yup:
Moochie
Active Member
When flat towed (all 4 wheels on the ground) transfer case needs to be in neutral with transmission in park. Just like it says in the manual.
JKAnimal
Caught the Bug
If your jeep is on a trailer it should be tied good enough that it doesn't move much. My buddies always trailer their Jeeps to CO. They attached the tie downs to the frame and trailer. Then tighten it up enough it won't move. Also roll with the E-brake on and typically in first.
Edit: The straps you see going in the door of the white Jeep is the slack from the ratchet straps.
Edit: The straps you see going in the door of the white Jeep is the slack from the ratchet straps.
Last edited:
Bigblake58
New member
I pull the e-brake, leave it in neutral, strap it down then throw it in park. I also run the straps to the axles for the best lockdown! And in the pic its not strapped down fully but you should get axle straps! (Shown on the rear axle) Best investment for trailering!!
Sent from my DROID RAZR MAXX HD using WAYALIFE mobile app
Sent from my DROID RAZR MAXX HD using WAYALIFE mobile app
