PDA

View Full Version : 2012 JKU Lift and Wheels



Damtall55
04-24-2012, 03:12 AM
Hey everyone, I recently purchased a TeraFlex 2.5" Lift Kit with Shocks. I have the stock 17's on now, but was looking to go with a 16x8 ATX wheels, 4.5" backspacing, with 33" BFG's once the lift is complete. Will I have any problems going from the 17 stocks to 16's? Any type of rubbing or unexpected problems? Any help or advice or thoughts would be most helpful and appreciated!!

wayoflife
04-24-2012, 04:14 AM
nah, you'll be just fine. 16" is the smallest wheel that is offered from the factory and truth be told, you can even get some 15" wheels to work.

Damtall55
04-24-2012, 12:55 PM
nah, you'll be just fine. 16" is the smallest wheel that is offered from the factory and truth be told, you can even get some 15" wheels to work.

Thank you for the help!! I sincerely appreciate it!! On a side note: I am looking to buy the ATX Slot in a 16x8. There is no offset, so I was worried about the rubbing. The BFG's I am looking at are either the 285/75R16's or the 295/75R16's. This is a DD/Commuter Jeep, which is why I didn't go with 35's. Yet!!

:thumb: Thanks again!!