Currie Lower Front Control Arms

went ahead an flipped the arms over. needed to pull one off anyway as i slight pull to the right. turns out one was set a touch too long. all better now except for i'll have to drop the arms in the future to grease them.
 
lower rough country

my rough country arms has zerts and they face down, only way the arms go for me and no problems after almost a year
 
my control arms use johnny joints and having them pointed up is a pain in the ass to grease.
IMO dropping the arms is too much work to do a quick grease job.
I have the some of the high clearance zerks to replace them all.
they'll also match the dynatrac ball joint zerks so no need to switch tips :thumb:
 
jeeeep said:
my control arms use johnny joints and having them pointed up is a pain in the ass to grease.
IMO dropping the arms is too much work to do a quick grease job.
I have the some of the high clearance zerks to replace them all.
they'll also match the dynatrac ball joint zerks so no need to switch tips :thumb:
Click to expand...

in the future, i'm going to switch to the high clearance zerks. i'll probably do that when i put in a new springs and have to adjust the arms again. :thumb:
 
You must log in or register to reply here.
Top Bottom