BearClaw
New member
I have an 09 JKUR that i lifted a while back. I put a 4" Zone Off Road lift under it mainly cause it was a little cheaper, the shop in town sells their parts and its Michigan made. (Where im from) The kit did not come with rear lower control arms. After the install i noticed there wasn't much room between my rear tires and the end of the stock rubi sliders. I always left it thinking no big deal since it doesn't rub much trail riding but at higher speeds at the dunes, (squatting the rear end in the woops) it rubs quite a bit.
So my question is.
If i put adjustable lower control arms on the rear will it push the axle back some to take care of the rub, and if so would i need a new drive shaft?
So my question is.
If i put adjustable lower control arms on the rear will it push the axle back some to take care of the rub, and if so would i need a new drive shaft?