What was done to your rig this week?
- Thread starter 10frank9
- Start date
JKbrick
Active Member
TOPLESS
Caught the Bug
Nice. I remember talking about this over a year ago.
jdofmemi
Active Member
That's nice
Just be sure to have a wood block or something to put in it for those times you need to jack against something flat.
dillard09
New member
Nice! I just bought something very similar from a company called Safe Jack. It's attachments that go on the bottle jack. I got a couple extensions, flat attachment, and a U attachment.
Five-N9ne
New member
Pulled the trans with the blown OD and reverse, scavenged the billet servos and accumulator out of them along with the built valvebody. Ready to install with new torque converter into the refreshed second tranny along with Oregon Performance clutches and bands, Superior front band strut, Sonnax rear band +.125” strut and a manual OD solenoid override.
Sent from my pay phone in Chechnya
Sent from my pay phone in Chechnya
Jsouder53
Hooked
JMFK
New member
Finally did a fender trim. Now I just need to finish the rear.
Sent from my iPhone using WAYALIFE mobile app
Sent from my iPhone using WAYALIFE mobile app
wjtstudios
Hooked
TrainWreck618
Caught the Bug
Bear_JT
Hooked
Bear_JT
Hooked
Just received and installed my Rigid Ignite back up lights. These things are bright! I’ll post some more pics once it’s dark.
Sent from my iPhone using WAYALIFE mobile app
Sent from my iPhone using WAYALIFE mobile app
Bear_JT
Hooked
These things are way brighter than I expected. I couldn’t get a good pic in the dark with how bright they are.
Sent from my iPhone using WAYALIFE mobile app
Sent from my iPhone using WAYALIFE mobile app
MrEmmDubya
New member
Dmac08JK
New member
buckweil
New member
I will be doing the same shortly. How was the install? What bit size did you use? I dont want them too loose.
jesse3638
Hooked
Finally got my king 2.5's installed. Took it up the road to the desert for a quick shake down. All I can say is I'm in trouble. I'm going to over drive my axles and break or bend them...haha. They replaced my 5100's and there is absolutely no comparison.
Sent from my 2PYB2 using WAYALIFE mobile app
Sent from my 2PYB2 using WAYALIFE mobile app
jtpedersen
Caught the Bug
New ball joints. Went with Synergy. If we follow-through with a lift and larger than 33” on our JK, then ProSteers next. For a JK, leveling lift, and 33s, I figure Synergy’s more than adequate.
It was my first time doing ball joints. While I’ve done all manner of other things, I just hadn’t done ball joints. Almost qualifies as a ‘fun’ job. Passenger lower was a real challenge. Ton of pressure, heated the knuckle, tried liquid wrench, some banging....wouldn’t budge. Stopped for dinner, went out and whacked the knuckle a few more times. Let loose. Sounded like a gun shot, dust floating...
Sent from my iPad using WAYALIFE mobile app
It was my first time doing ball joints. While I’ve done all manner of other things, I just hadn’t done ball joints. Almost qualifies as a ‘fun’ job. Passenger lower was a real challenge. Ton of pressure, heated the knuckle, tried liquid wrench, some banging....wouldn’t budge. Stopped for dinner, went out and whacked the knuckle a few more times. Let loose. Sounded like a gun shot, dust floating...
Sent from my iPad using WAYALIFE mobile app