What was done to your rig this week?
- Thread starter 10frank9
- Start date
metalic
Member
I measured from center of tube to bottom of Center and have more clearance than my factory 44
Fits in a 7' garage door. Sitting on 3.5" RK springs but gained a 1/2" with the tube size when measured compared to 44.
It required a lot of cutting and a BFH.
Ruvicon
Member
Replaced my front shocks today with Fox 2.0s. Drives much better!
Sent from my iPhone using WAYALIFE mobile app
Sent from my iPhone using WAYALIFE mobile app
Jsouder53
Hooked
What did you have before?
Ruvicon
Member
Rancho N2.0s. They were shot. I replaced them as they were leaking, but once I took off the drivers side, it had no pressure at all, nothing. The other side wasn’t much better.
Sent from my iPhone using WAYALIFE mobile app
Jsouder53
Hooked
Well I’m glad it’s driving much better! I had a set of similar rough country shocks and it was the same thing for me... no pressure at all.
Jsouder53
Hooked
That’s looking good!
boardsurfer
Active Member
What am I looking at here? I suppose the blue line is for the locker - whats that other line? Is it steel braided?
JKbrick
Active Member
PokerStogey
Member
deantac
Member
Thanks....
deantac
Member
Blue line is ARB line that I stuck in there to keep crud out.....and the braided line is brake lines that will run up the upper link. I connected them to keep crud out also.
jdofmemi
Active Member
I love the idea of running the brake lines down the upper link. That should keep them out of harm's way.
Great build!
boardsurfer
Active Member
Oh I get it! Cool.
mattfl
New member
Added a GMRS radio this weekend. Wanted a way to mount it to my roll cage so came up with this mount and 3D printed it. Originally had it on the lower bar but found it worked better on the upper one.
Sent from my iPad using WAYALIFE mobile app
Sent from my iPad using WAYALIFE mobile app