The Birth of Cookie Monster (aka Cymbol Monkey)

Weebz

Caught the Bug
I’d like pics please when you have time. I don’t like where I got the power for mine


Sent from my iPhone using WAYALIFE mobile app

Sorry for the delays. I went cheap on my switch system and bought an Amazon Applootech switch. Few guys around me run them with no issues so I’m giving it a try. Everything wired up super easy and works like a charm.
 

Attachments

  • 452D6789-33A5-4923-8314-FAB825869DA1.jpeg
    452D6789-33A5-4923-8314-FAB825869DA1.jpeg
    95.8 KB · Views: 95

Weebz

Caught the Bug
So I have been busy but not staying up to speed on the thread. I’m to the point where I’m just flat out ready to be done.

I indeed got the ARB mounted up under the seat after ditching my original terraflex bracket which I hated. The compressor basically was pressed up against all the seat wire harnesses with zero clearance from the compressor to the bottom of the seat.
 

Attachments

  • A75CDB7D-BAB2-4466-873C-CCB138979530.jpeg
    A75CDB7D-BAB2-4466-873C-CCB138979530.jpeg
    156.2 KB · Views: 92

Weebz

Caught the Bug
Also got my new 8” ram installed. Had to grind down my steer stops more to accommodate the longer ram. Similar to Bill, I will need to get new tabs welded to accommodate my set up. At full steer the ram hits the drag link. I’ve rotated moved and twisted it every which way but alas I gave up
And bolted it down until it goes to the shop for final tune and they can weld some tabs in a better location.
 

Attachments

  • 922F0FB9-731D-4337-B84F-BCB5B6C5D1A3.jpeg
    922F0FB9-731D-4337-B84F-BCB5B6C5D1A3.jpeg
    136 KB · Views: 90
  • 91DDA1E6-FFD4-4D17-97E0-A55F718DF0A8.jpeg
    91DDA1E6-FFD4-4D17-97E0-A55F718DF0A8.jpeg
    124.5 KB · Views: 90
  • 7418C09D-AFBC-495F-A3EA-E14A1A4C758D.jpeg
    7418C09D-AFBC-495F-A3EA-E14A1A4C758D.jpeg
    29.1 KB · Views: 90

Weebz

Caught the Bug
Also finally got my new ebrake cables delivered. wasn’t sure what to expect on this task but honestly
far easier than I thought. Hardest part was disconnecting all the seat wiring again to rip the center console out. Still need to figure out a better way to secure the cables to the control arms.
 

Attachments

  • D875DE94-7E8A-4401-8A5E-7DB8D056D0F6.jpeg
    D875DE94-7E8A-4401-8A5E-7DB8D056D0F6.jpeg
    105.8 KB · Views: 91
  • 267A3D9E-80FF-4637-9158-4C0E478FF769.jpeg
    267A3D9E-80FF-4637-9158-4C0E478FF769.jpeg
    125.2 KB · Views: 91
  • 1EB80CE2-7836-47E3-B1A4-8F609035C59F.jpeg
    1EB80CE2-7836-47E3-B1A4-8F609035C59F.jpeg
    133.2 KB · Views: 89
  • 9EC32ABF-BBAC-49EB-9258-66CF8754559B.jpeg
    9EC32ABF-BBAC-49EB-9258-66CF8754559B.jpeg
    158.4 KB · Views: 89
  • 7270BE1B-775E-4CEB-880A-23B39BE68F67.jpeg
    7270BE1B-775E-4CEB-880A-23B39BE68F67.jpeg
    177.7 KB · Views: 88
  • 9644E428-D8D1-4D0A-B20E-8B0732E5B9A3.jpeg
    9644E428-D8D1-4D0A-B20E-8B0732E5B9A3.jpeg
    104 KB · Views: 86
  • 1EDF7818-3A5D-4F08-8D48-5E7C9CBA7021.jpeg
    1EDF7818-3A5D-4F08-8D48-5E7C9CBA7021.jpeg
    89 KB · Views: 85

Weebz

Caught the Bug
Only issue with new cables is it’s pulling uneven right now. Driver pulls further than passenger. Seems to be holding though
 

OverlanderJK

Resident Smartass
The evo long arms just have a small tab welded on them that you zip tie the cable to. I would get a bigger cable though. That little one will snap.


Sent from my iPhone using WAYALIFE
 

Weebz

Caught the Bug
And finally....ripped all the rock sliders off and am refinishing them. Painted the sill black though while off until I go full skins. Also took the stinger off and repainted it.

And if you notice...the Jeep is actually nose in the garage now. Indeed I finally took her for a spin up and down my driveway. Damn near cried. Need to bleed my brakes...again as they are real soft. Possible I may have a leak in my booster though as I’m hearing a lot of “whoosh” when I hit the brakes. But if I pump them rapidly it stiffens up (enter wise ass comments).
 

Attachments

  • 59FB67DD-6B36-4BB1-B9F6-3A5D9C30FA5E.jpeg
    59FB67DD-6B36-4BB1-B9F6-3A5D9C30FA5E.jpeg
    111.6 KB · Views: 93
  • A5A1203A-CB01-449C-A263-5C476A6B5F7D.jpeg
    A5A1203A-CB01-449C-A263-5C476A6B5F7D.jpeg
    108.2 KB · Views: 93

Weebz

Caught the Bug
The evo long arms just have a small tab welded on them that you zip tie the cable to. I would get a bigger cable though. That little one will snap.


Sent from my iPhone using WAYALIFE

I’ll take a look but pretty sure the cable is the same diameter. The 14 bolt has a different connection and that is what I needed. Good eye though. I will definitely double check
 
Top Bottom