Finished my fender chop

aldaman

aldaman

Member
Looks good. What tool did you use to make the cut and did you do it with the fenders still installed?
 
Dave_g

Dave_g

New member
Used a dremel with thin 1 in cutting discs, then a belt sander with 120 grit to level every thing while they were off, once I installed everything I used 120 on a sanding block and then 220 to smooth it out and finish with a nice rounded edge.
 
desertrunner

desertrunner

Active Member
i used a dremil to do my front and it worked fine but it took a long time i just invested in a $30 angle grinder from home depot and it chopped through my rear fenders like butter and took maybe 60 seconds on each side and it cuts through the sheet metal pinch seam like butter too it was a great investment and is much easier to control than a sawzall
 
billybob990

billybob990

New member
How wide are your stock flares? I have a tj and have been looking into getting extended flares to cut but don't know how wide I should go. The widest I have found is 7".
 
You must log in or register to reply here.
Top Bottom