What is everyone running for a front bump stop extension height? I'm using the King air bumps and with the C/O bottoming out being the limiting factor I'm at roughly 3.75" of bump stop extension and 2 threads showing above the King air bumps. Does that seem about average? This is on a PR44 which seems to have a lower pad than stock.
I am getting ready to do this install myself. Did long arms earlier this month. I also have a PR44. If memory serves, the bumpstop pad comes with a small spacer (maybe 3/4 inch or something like that. I believe it's something to do with difference in the TJ to JK bumpstop height.
Edit: This is from the FAQ for the PR44. I was way off with the 3/4 inch spacer. It's .880. Pasted below...
The JK ProRock 44 housing shares a common coil seat with the TJ axle assemblies. From the
factory, the JK bump stop target on the axle is taller than the one on the TJ axle. The Dynatrac bump
stop target needs a 0.880” spacer to make up the difference and bring the bump stop target location
back to stock. If you have a lift kit which includes a bump stop spacer you will need to stack both of
the spacers up in series in order to establish the correct bump stop position.
I'm not sure if it's okay to post this here. If I did something wrong I apologize...
https://www.dynatrac.com/downloads/ProRock FAQ_revK.pdf